Evaluation of a proper controller performance for maximum-power point tracking of a stand-alone PV system

In this paper the implementation of a suggested stand-alone PV system, for maximum-power point tracking (MPPT), is carried out. Also, this paper presents a comparative study, through experimental work, between the conventional PI controller and the fuzzy logic controller (FLC) under different atmospheric conditions. The implemented system with both the PI controller and the FLC gives a good maximum-power operation of the PV array, but the tracking capability for different optimum operating points is better and faster for the case of using the FLC compared to the case of using the PI controller.     

超微粒子的量子阻尼振动理论

根据SU(1,1)Lie代数,建立超微粒子的量子阻尼振动理论,得到超微粒子量子阻尼振动系统的能级和波函数。     

湖泊藻类叶绿素-α和悬浮物浓度的高光谱定量遥感模型研究

本文利用地物光谱仪对太湖水体进行了光谱测量和同步采样分析，对获得的数据尝试用光谱分离法进行分析，从中分离出蓝藻和悬浮物的特征波峰，建立波峰高度与同步水质采样得到的叶绿素-α浓度和悬浮物浓度的对应关系，得出其遥感定量反演算法，并实际应用在OMIS成像光谱仪图像上．     

用激光粒度分析仪测定二氧化锆粒度

介绍以六偏磷酸钠作为分散剂，采用激光粒度分析仪测量二氧化锆粒度的一种新方法。该方法的测量范围为0．05～300μm。     

Heat transfer mechanism of a swirling impinging jet in a stagnation region

Heat transfer characteristics of a swirling impinging jet have been experimentally examined using a combined particle image velocimetry (PIV) and laser‐induced fluorescence (LIF) technique for simultaneous measurement of velocity and temperature fields. The present study shows that the radial width of the jet stretches with increasing swirl intensity, and that the stretching phenomenon contributes to the maximum local heat transfer coefficient. At the stagnation region, the flow near the heated surface is mixed intermittently by reverse flows toward upstream, and spatial distributions of temperature are correlated with instantaneous velocity vector maps. The dynamic behavior of recirculation zones, attributed to swirl number Sw and impinging distance, mainly determines the turbulent heat transfer at the stagnation region. © 2003 Wiley Periodicals, Inc. Heat Trans Asian Res, 32(8): 663–673, 2003; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.10120     

基于TiNi合金的超弹性对其相关磨损机制的FEM研究

本文在重点考虑TiNi合金高弹性变形量的前提下，采用等向强化模型，对不锈钢和超弹TiNi合金在法向接触载荷作用下的六种模型进行了有限元(FEM)分析。结果表明：在相同载荷条件下，超弹TiNi合金产生的von Mises弹性应变要高于不锈钢，但其von Mises应力和塑性应变却恰恰相反，在同一载荷下该合金发生塑性变形的区域要小于不锈钢；此外，超弹TiNi合金发生塑性变形要比不锈钢困难，所需的临界载荷值随其最大弹性变形量(屈服点处的应变值)的增加而增加。最后，基于本文的有限元计算结果对超弹TiNi合金的蘑粒磨损和疲劳磨损机制进行了讨论。     

Robust图像跟踪：强度—特征混合式目标定位

在像平面上确定目标的位置(由它的瞄准点位置表示)是图像跟踪技术的核心.目前研究的目标是图像定位方法多偏重于单一的工作模式,因而难以适应变化较大的使用环境.本文提出一种旨在综合利用强度相关和特征匹配的混合式目标图像定位方法.假定当前帧图像已经过预处理并完成分割,首先通过一种自适应门限SSDA并辅之以投影排序搜索,尽可能快速地剔除与参考图差别较大的子区;再用一种简便可靠并可具一定记忆能力的特征匹配法,在保留的子区集内,为目标精确定位——宣布瞄准点位置.利用实际序列图像所作实验表明:上述方法较之通常采用的单一工作模式的定位方法,有明显增强的Robust性以及更广的适应性,而增加的计算代价不大.     

机械臂的动态混合控制

本文研究当机械臂的终端受有约束时的控制问题,其中心内容是给出“任务规范投影算子”的概念,利用它首先将机械臂的动态方程解耦为两组方程,它们分别描述了运动与约束力,在此基础上给出了机械臂的控制律,使闭环系统跟踪期望的速度与约束力。     

星间激光通信技术进展与趋势

较详细地评述了目前国外卫星间光通信技术研究的现状．根据关键单元技术的进展情况，总结了未来星间光通信系统的发展趋势。     

Sorption of Acid Green 25 on chitosan: Influence of experimental parameters on uptake kinetics and sorption isotherms

Acid Green 25, which is a diazoic dye bearing two sulfonic groups, is efficiently sorbed on chitosan. The protonation of chitosan may explain the electrostatic attraction of this anionic dye and that its optimum pH is close to 3. Preliminary protonation of amine groups (obtained by contact with a sulfuric acid solution) reduced the variation of solution pH following sorbent addition but significantly reduced sorption performance: the maximum sorption capacity of raw chitosan, 525 mg dye/g (0.84 mmol dye/g), was halved by acidic preconditioning. The acidic conditioning also reduced the kinetic rate—the time necessary to reach equilibrium increased up to threefold depending on the experimental conditions. The size of sorbent particles influenced sorption kinetics and equilibrium because of resistance to intraparticle diffusion, but the sorption appeared to occur not only at the surface of the sorbent but also in the intraparticle network of the polymer. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 1073–1080, 2003